RX400h · Service Manual ENGINE

REMOVAL

Removal / installation


1. REMOVE COOL AIR INTAKE DUCT SEAL

  1. Remove the 4 clips and cool air intake duct seal.


2. REMOVE AIR CLEANER CAP W/ INLET

  1. A108124
    Remove the 2 bolts, 4 clamps and air cleaner cap w/ inlet.

  1. Remove the air cleaner filter element from the air cleaner case.


3. REMOVE VVT SENSOR (for Bank 1)

  1. A079541E01
    Disconnect the VVT sensor (Bank 1) connector.

  1. Remove the bolt, and then remove the VVT sensor (Bank 1).


4. REMOVE VVT SENSOR (for Bank 2)

  1. A108296E01
    Disconnect the heated oxygen sensor connector (Bank 2) from the wire harness bracket.

  1. A078529E01
    Disconnect the VVT sensor (Bank 2) connector.

  1. Remove the bolt, and then remove the VVT sensor (Bank 2).

← COMPONENTSINSPECTION →