DATA LIST / ACTIVE TEST
System information
| DATA LIST |
The wireless door lock control data list can be displayed while the intelligent tester is connected to the DLC3 with the ignition switch in the ON position. Follow the prompts on the tester screen to access the DATA LIST.
Body: Item (Display)
Measurement Item / Display (Range)
Normal Condition
Diagnostic Note
IG SW
Ignition switch (IG) / ON or OFF
ON: Ignition switch ON or START
OFF: Ignition switch OFF or ACC
-
ACC SW
Ignition switch (ACC) / ON or OFF
ON: Ignition switch ACC
OFF: Ignition switch in any position except ACC
-
Key Unlock Warning SW
Unlock warning switch / ON or OFF
ON: Ignition key is inserted
OFF: Ignition key is not inserted
-
Wireless Control
Wireless door lock control function / ON or OFF
ON: Operates
OFF: Does not operate
-
Hazard Answer Back
Hazard answer-back of wireless / ON or OFF
ON: Operates
OFF: Does not operate
-
Open Door Warning
Open door warning / ON or OFF
ON: Operates
OFF: Does not operate
-
Auto Lock Time
Automatic lock time / 60 s or 30 s
60 s: 60 seconds
30 s: 30 seconds
-
Wireless Buzzer Resp
Wireless door lock buzzer response / ON or OFF
ON: Operates
OFF: Does not operate
-
D Door Courtesy SW
Driver side door courtesy light switch / ON or OFF
ON: Door is opened
OFF: Door is closed
-
P Door Courtesy SW
Passenger side door courtesy light switch / ON or OFF
ON: Door is opened
OFF: Door is closed
-
Rr Door Courtesy SW
Rear door courtesy light switch / ON or OFF
ON: Either LH or RH door is opened
OFF: Both LH and RH doors are closed
-
Passenger Lock Pos SW
Passenger side door lock position switch / ON or OFF
ON: Door lock is in the unlock position
OFF: Door lock is in the lock position
-
Rear Lock Position SW
Rear door lock position switch / ON or OFF
ON: Door lock is in the unlock position
OFF: Door lock is in the lock position
-
| ACTIVE TEST |
- HINT:
- Performing the ACTIVE TEST using the intelligent tester allows components such as the relay, VSV and actuator to operate without removing parts. Performing the ACTIVE TEST as the first step in troubleshooting is one way to shorten labor time.
- It is possible to display the DATA LIST during the ACTIVE TEST.
Connect the intelligent tester to the DLC3.
Turn the ignition switch to the ON position.
According to the display on the tester, preform the ACTIVE TEST.
- HINT:
- The ignition switch must be turned to the ON position to proceed with the ACTIVE TEST using the intelligent tester.
Body: Item (Display)
Vehicle Condition / Test Details
Diagnostic Note
Hazard
Turns the turn signal flasher relay ON / OFF
Observe headlight and rear combination light for correct operation
Buzz Resp Sound
Turns the wireless door lock buzzer ON / OFF
Buzzer can be heard