Rear Power Window Switch RH Circuit

DESCRIPTION

This circuit supplies power to operate the multiplex network switch.

WIRING DIAGRAM

INSPECTION PROCEDURE

1. CHECK WIRE HARNESS (MULTIPLEX NETWORK SWITCH - BATTERY AND BODY GROUND)

1. Disconnect the P18 connector.

2. Measure the voltage and resistance according to the value(s) in the table below.

   Standard voltage:

   Tester Connection	Condition	Specified Condition
   P18-12 (BDR) - Body ground	Always	10 to 14 V

   Standard resistance:

   Tester Connection	Condition	Specified Condition
   P18-7 (GND) - Body ground	Always	Below 1 Ω

NG	REPAIR OR REPLACE HARNESS OR CONNECTOR

OK
PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE