RX400h · Service Manual ENGINE

REMOVAL

Removal / installation


1. REMOVE ENGINE UNDER COVER NO.1

  1. A108722
    Remove the 6 bolts, 2 screws, 2 clips and engine under cover.


2. REMOVE FRONT FENDER SPLASH SHIELD SUB-ASSEMBLY RH

  1. A080511
    Remove the screw, and then open the front fender splash shield sub-assembly RH.


3. REMOVE FRONT FENDER APRON SEAL RH

  1. A080512
    Remove the clip and 2 bolts, and then remove the front fender apron seal RH.


4. REMOVE CRANKSHAFT POSITION SENSOR

  1. A079763
    Disconnect the crankshaft position sensor connector.

  1. Remove the bolt, and then remove the crankshaft position sensor.

← COMPONENTSINSPECTION →