INSPECTION

Inspection

INSPECT IGNITION SWITCH

1. Measure the resistance according to the value(s) in the table below.
   

   Standard:

   Switch Condition	Tester Connection	Specified Condition
   LOCK	Between all terminals	10 kΩ or higher
   ACC	2 (AM1) - 3 (ACC)	Below 1 Ω
   ON	2 (AM1) - 3 (ACC) 2 (AM1) - 4 (IG1) 5 (IG2) - 6 (AM2)	Below 1 Ω
   START	1 (ST1) - 2 (AM1) 1 (ST1) - 4 (IG1) 5 (IG2) - 6 (AM2) 5 (IG2) - 7 (ST2)	Below 1 Ω

   If the result is not as specified, replace the ignition switch.