RX400h · Service Manual BODY

INSTALLATION

Removal / installation


1. INSTALL REAR DOOR WINDOW FRAME MOULDING

  1. B068609E01
    Remove the tape from the moulding.

  1. Clean the contact surface of the body with white gasoline.

  1. Clean the outer circumference of the moulding with white gasoline.

  1. Apply new double-sided tape to the moulding, as shown in the illustration.

    Dimension:
    A
    		 400.0 mm (15.748 in.)
    B
    		 5.0 mm (0.197 in.)
    C
    		 1.2 mm (0.047 in.)

  1. Using a heat light, heat the body and moulding.

    Heating temperature:
    Body
    		 40 to 60°C (104 to 140°F)
    Moulding
    		 20 to 30°C (68 to 86°F)

    NOTICE:
    Do not heat the body and moulding excessively.

  1. Remove the release paper from the moulding face.

    HINT:
    Be careful that dirt or foreign objects do not stick to the adhesive part when removing the peeling paper.

  1. Engage the 2 claws and install the moulding with the screw.

    NOTICE:
    Do not apply excessive force onto the moulding, but apply steady pressure with your thumbs.

← REMOVALCOMPONENTS →