RX400h · Service Manual BODY ELECTRICAL

REMOVAL

Removal / installation


1. REMOVE MAP LIGHT ASSEMBLY

  1. B110371
    w/o Sliding roof:
    Using a screwdriver, disengage the 6 claws and remove the lens cover.

    HINT:
    Tape the screwdriver tip before use.

  1. B111799
    w/ Sliding roof:
    Using a screwdriver, disengage the 8 claws and remove the lens cover.

    HINT:
    Tape the screwdriver tip before use.

  1. B115594
    Using a screwdriver, disengage the claws and open the cover.

    HINT:
    Tape the screwdriver tip before use.

  1. B111798E01
    Using a screwdriver, disengage the claws and open the 2 caps, as shown in the illustration.

    HINT:
    Tape the screwdriver tip before use.

  1. B110372
    Remove the 4 screws and map light.

  1. Disconnect the connector.


2. REMOVE MICROPHONE AMPLIFIER

  1. I045255
    Disconnect the connector.

  1. Remove the screw and the microphone amplifier.

← COMPONENTSINSTALLATION →