RX400h · Service Manual BODY

INSPECTION

Inspection


INSPECT POWER WINDOW REGULATOR MOTOR (FRONT RH)

  1. B067305E01
    Remove the power window regulator motor.

  1. Apply battery voltage to the motor connector according to the table below.

    NOTICE:
    Do not apply battery to any terminals except terminals 1 and 2.

    Standard:
    Measurement Condition
    		 Specified Condition
    Battery positive (+) → Terminal 1 (D)
    Battery negative (-) → Terminal 2 (U)
    		 Motor gear rotates clockwise
    Battery positive (+) → Terminal 2 (U)
    Battery negative (-) → Terminal 1 (D)
    		 Motor gear rotates counterclockwise


INSPECT POWER WINDOW REGULATOR MOTOR (FRONT LH)

  1. B067306E01
    Remove the power window regulator motor.

  1. Apply battery voltage to the motor connector according to the table below.

    NOTICE:
    Do not apply battery to any terminals except terminals 1 and 2.

    Standard:
    Measurement Condition
    		 Specified Condition
    Battery positive (+) → Terminal 1 (D)
    Battery negative (-) → Terminal 2 (U)
    		 Motor gear rotates counterclockwise
    Battery positive (+) → Terminal 2 (U)
    Battery negative (-) → Terminal 1 (D)
    		 Motor gear rotates clockwise


INSPECT POWER WINDOW REGULATOR NOTOR (REAR RH)

  1. B067305E01
    Remove the power window regulator motor.

  1. Apply battery voltage to the motor connector according to the table below.

    NOTICE:
    Do not apply battery to any terminals except terminals 1 and 2.

    Standard:
    Measurement Condition
    		 Specified Condition
    Battery positive (+) → Terminal 1 (D)
    Battery negative (-) → Terminal 2 (U)
    		 Motor gear rotates clockwise
    Battery positive (+) → Terminal 2 (U)
    Battery negative (-) → Terminal 1 (D)
    		 Motor gear rotates counterclockwise


INSPECT POWER WINDOW REGULATOR MOTOR (REAR LH)

  1. B067306E01
    Remove the power window regulator motor.

  1. Apply battery voltage to the motor connector according to the table below.

    NOTICE:
    Do not apply battery to any terminals except terminals 1 and 2.

    Standard:
    Measurement Condition
    		 Specified Condition
    Battery positive (+) → Terminal 1 (D)
    Battery negative (-) → Terminal 2 (U)
    		 Motor gear rotates counterclockwise
    Battery positive (+) → Terminal 2 (U)
    Battery negative (-) → Terminal 1 (D)
    		 Motor gear rotates clockwise

← Rear Power Window Motor RH CircuitCOMPONENTS →