CHECK MODE PROCEDURE
Troubleshooting
| CHECK MODE (SIGNAL CHECK): DTC CHECK |
Connect the intelligent tester to the DLC3.
Turn the ignition switch to the ON position.
Select "SIGNAL CHECK", and proceed to checking with the intelligent tester.
- NOTICE:
- Select "SIGNAL CHECK" from the "DTC CHECK" screen displayed on the intelligent tester to clear the output DTCs (both present and past).
- HINT:
- DTCs can be detected more sensitively in check mode than in normal diagnosis mode.
- Perform check mode inspection when a malfunction in each squib circuit is suspected even after the normal system code is output through normal diagnosis mode inspection.
- DTCs can be detected more sensitively in check mode than in normal diagnosis mode.