RX400h · Service Manual RESTRAINTS

INSPECTION

Inspection


INSPECT INTEGRATION CONTROL & PANEL (W/O NAVIGATION SYSTEM)

  1. B115739E01
    Disconnect the C4 connector.

  1. Measure the voltage and resistance according to the value(s) in the table below.

    Standard voltage:
    Tester Connection
    		 Condition
    		 Specified Condition
    C4-9 (IG) - Body ground
    		 Ignition switch ON
    		 10 to 14 V

    Standard resistance:
    Tester Connection
    		 Condition
    		 Specified Condition
    C4-7 (GND) - Body ground
    		 Always
    		 Below 1 Ω


INSPECT MULTI-DISPLAY (W/ NAVIGATION SYSTEM)

  1. B111225E03
    Disconnect the M1 connector.

  1. Measure the voltage and resistance according to the value(s) in the table below.

    Standard voltage:
    Tester Connection
    		 Condition
    		 Specified Condition
    M1-10 (IG+) - Body ground
    		 Ignition switch ON
    		 10 to 14 V
    M1-21 (PBEW) - Body ground
    		 Ignition switch ON, sit on the front passenger seat, seat belt is unfastened → Fastened
    		 10 to 14 V → Below 1 V

    Standard resistance:
    Tester Connection
    		 Condition
    		 Specified Condition
    M1-3 (GND) - Body ground
    		 Always
    		 Below 1 Ω

← INSTALLATIONPARTS LOCATION →