Door Opening Relay Power Source Circuit

DESCRIPTION

This circuit supplies power to operate the door opening relay assembly (double lock relay).

WIRING DIAGRAM

INSPECTION PROCEDURE

1. CHECK WIRE HARNESS (DOOR OPENING RELAY - BATTERY AND BODY GROUND)

1. Disconnect the door opening relay connector.

2. Measure the resistance according to the value(s) in the table below.

   Standard resistance:

   Tester Connection	Condition	Specified Condition
   D2-14 (GND) - Body ground	Always	Below 1 Ω

3. Measure the voltage according to the value(s) in the table below.

   Standard voltage:

   Tester Connection	Condition	Specified Condition
   D2-1 (+B) - Body ground	Always	10 to 14 V
   D2-7 (CPUB) - Body ground	Always	10 to 14 V

NG	REPAIR OR REPLACE HARNESS OR CONNECTOR

OK
PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE