RX400h · Service Manual BODY ELECTRICAL

INSTALLATION

Removal / installation


1. INSTALL DOOR CONTROL RECEIVER

  1. B106896
    Install the door control receiver with the bolt.

  1. Connect the connector.


2. INSTALL ROOF SIDE GARNISH ASSEMBLY INNER

  1. B111796
    Engage the 7 clips and install the roof side garnish assembly inner.

  1. B111795
    Install the 3 clips.

  1. Install the 3 bolts and tonneau cover holder cap.

  1. B111797
    Engage the 4 claws and install the seat belt bezel.


3. INSTALL NO.2 ROOM LIGHT ASSEMBLY

  1. B111794
    Connect the connector.

  1. Engage the claw and install the room light assembly No.2.


4. INSTALL DECK TRIM SIDE PANEL ASSEMBLY

  1. B111793
    Engage the 2 clips and install the deck trim side panel assembly.

  1. Install the 4 clips.


5. INSTALL ROPE HOOK

  1. Install the 2 rope hooks with the 2 bolts.

    Torque:
    8.0 N*m{ 80 kgf*cm , 71 in.*lbf }

    HINT:
    Use the same procedure to install the other side.


6. INSTALL REAR FLOOR FINISH SIDE PLATE

  1. B111792
    Engage the 2 clips and install the rear floor finish side plate.

  1. Install the clip.


7. INSTALL REAR SEAT SIDE COVER

  1. B111791
    Engage the 4 clips and install the rear seat side cover.

  1. Install the 3 clips.


8. INSTALL REAR NO.1 SEAT BELT ASSEMBLY OUTER

  1. Install the rear No.1 seat outer belt assembly with the bolt.

    Torque:
    42 N*m{ 428 kgf*cm , 31 ft.*lbf }


9. INSTALL DECK SIDE TRIM COVER

  1. B111808
    Engage the 5 claws and install the deck side trim cover.


10. INSTALL REAR DOOR OPENING TRIM WEATHERSTRIP

11. INSTALL REAR DOOR SCUFF PLATE

  1. B111783
    Connect the connector. (w/ illumination scuff plate)

  1. Engage the 4 claws and 2 clips, and install the rear door scuff plate.


12. INSTALL DECK SIDE TRIM BOX LH

  1. B111781
    Install the deck side trim box with the 2 clips.


13. INSTALL DECK SIDE TRIM BOX RH

14. INSTALL REAR FLOOR FINISH PLATE

  1. B110477
    Engage the 2 claws and 6 clips, and install the rear floor finish plate.

  1. Install the 2 clips.


15. INSTALL BACK DOOR WEATHERSTRIP

16. INSTALL NO.3 DECK BOARD SUB-ASSEMBLY

  1. B110025
    Install the deck No.3 board sub-assembly with the 2 bolts and 2 nuts.


17. INSTALL NO.2 DECK BOARD SUB-ASSEMBLY

  1. B110024
    Install the deck No.2 board sub-assembly with the 4 bolts and 2 nuts.


18. INSTALL DECK FLOOR BOX REAR

  1. B110023
    Install the deck floor box rear with the 2 clips.


19. INSTALL DECK FLOOR BOX FRONT

  1. B110022
    Install the deck floor box front with the 2 clips.


20. INSTALL DECK BOARD SUB-ASSEMBLY

  1. B110455
    Install the deck board sub-assembly with the 2 bolt.

  1. Engage the 5 clips.


21. INSTALL TONNEAU COVER ASSEMBLY
← REMOVALPRECAUTION →