RX400h · Service Manual BODY ELECTRICAL

INSPECTION

Inspection


INSPECT LIGHT CONTROL RHEOSTAT

  1. E111191E04
    Remove the light control rheostat with connector still connected.

  1. I032117E01
    Measure the resistance according to the value(s) in the table below.
    Standard Resistance 
    Tester Connection
    		 Condition
    		 Specified Condition
    R6-1 (E) - R6-7 (RV)
    		 Light control rheostat is in the MIN. position.
    		 Below 1 Ω
    R6-1 (E) - R6-7 (RV)
    		 Light control rheostat is in the MAX. position.
    		 8 to 12 kΩ
    R6-1 (E) - R6-7 (RV)
    		 ODO/TRIP switch is OFF → ON
    		 10 kΩ or higher →
    Below 1 Ω

    HINT:
    If the value is not as specified, replace the light control rheostat.

← INSPECTIONPRECAUTION →