INSPECTION
Inspection
| INSPECT TIRE |
Check the tires for wear and proper inflation pressure.
Cold tire inflation pressure Tire size
For driving under 180 km/h (112 mph)
kPa (kgf/cm2, psi)
For driving at over 180 km/h (112 mph)
kPa (kgf/cm2, psi)
235/55R18 99V
220 (2.2, 32)
230 (2.3, 34)
235/55R18 100V
220 (2.2, 32)
230 (2.3, 34)
Using a dial indicator, check the tire runout (vertical and horizontal).
- Tire runout:
- 1.0 mm (0.039 in.) or less
| ROTATE TIRES |
See the illustration for where to rotate each tire.
| INSPECT WHEEL BALANCE |
Check and adjust the off-the-car balance.
If necessary, check and adjust the on-the-car balance.
- Imbalance after adjustment:
- 8.0 g (0.018 lb) or less
| INSPECT BEARING LOOSENESS |
Using a dial indicator, check for looseness near the center of the axle hub.
- Maximum:
- 0.05 mm (0.0020 in.)
- NOTICE:
- Ensure that the dial indicator is set at right angles to the measurement surface.
- HINT:
- If looseness exceeds the maximum, replace the bearing.
| INSPECT AXLE HUB RUNOUT |
Using a dial indicator, check for runout on the surface of the axle hub outside the hub bolt.
- Maximum:
- 0.05 mm (0.0020 in.)
- NOTICE:
- Ensure that the dial indicator is set at right angles to the measurement surface.
- HINT:
- If runout exceeds the maximum, replace the axle hub.