Place the transaxle selector lever in the neutral position.
Loosen the switch mounting bolts.
Fig. 1: With the switch in the neutral position,
insert the proper size pin into the adjustment hole and tighten the
attaching screws
Remove the screw on the switch body and move the switch so that the screw
hole is aligned with the small hole inside of the switch. Check the alignment
by inserting a small pin (0.079 in. or 2mm for all models except Millenia,
which uses a 0.157 in. or 4mm pin) in the hole.
Tighten the mounting bolts and remove the pin.
Install the screw to the switch body and tighten.
Check the adjustment by trying to start the engine in all gears. It should
only start in Park and Neutral.
