Knock Sensor (KS)

Removal & Installation

To Remove:

1. Disconnect the negative battery cable.
2. Raise and support the vehicle.
3. Disconnect the knock sensor (KS) electrical connector.
4. Remove the bolt and the KS.

To Install:

1. Install the bolt and KS.
   • Torque to 18 ft-lb (25 Nm).

   NOTE: The KS is designed to only be used once, so if it is serviced you must install a new KS.

2. Connect the KS electrical connector.
3. Lower the vehicle.
4. Connect the negative battery cable.