Knock Sensor (KS)

Removal & Installation

To Remove:

1. Disconnect the negative battery cable.
2. Remove the intake manifold.
3. Disconnect the knock sensor (KS) electrical connector.
4. To remove the KS, first remove the bolt, then remove the sensor.

To Install:

1. Install the KS and bolt.
   • Torque to 15 ft-lb (20 Nm).

   NOTE: The KS is designed to only be used once, so if it is serviced you must install a new KS.

2. Connect the KS electrical connector.
3. Install the intake manifold.
4. Connect the negative battery cable.