REAR WHEEL ALIGNMENT

B3E021101016W01

**Specification (Unloaded)*1**


Item			Fuel gauge indication
Item			Empty	1/4	1/2	3/4	Full
Total toe-in	Tire [Tolerance ±4 {±0.16}]	(mm {in})	2 {0.08}
	Rim inner	(mm {in})	1±3 {0.04±0.12}
	(degree)		0°11'±0°22'
Camber angle^*2(Reference value) [Tolerance ±1°]			-1°10'	-1°12'	-1°14'	-1°17'	-1°19'
Thrust angle (Reference value) [Tolerance ±0°48']			0°

*¹ :

Engine coolant and engine oil are at specified level. Spare tire, jack and tools are in designated position.

*² :

Difference between left and right must not exceed 1°30' .

Note

Total toe-in measuring position

• Tire: A indicated in the figure (between the center of the tires)

• Rim inner: B indicated in the figure (between the inner side of the rims)

1. Loosen the installation nut of the adjusting cam bolt.

2. Rotate the adjusting cam bolt in either direction to adjust the camber.


	Left wheel	Right wheel
Toe-out direction	Clockwise	Counterclockwise
Toe-in direction	Counterclockwise	Clockwise

3. Tighten the nut.

Tightening torque

80.0-100.0 N·m {8.16-10.19 kgf·m, 59.01-73.75 ft·lbf}