MANUAL TRANSAXLE REMOVAL/INSTALLATION [G35M-R]

B3E051501029W07

1. Remove the following parts:

(1) Battery and battery tray
(See BATTERY REMOVAL/INSTALLATION [LF].)
(2) Air cleaner component
(See INTAKE-AIR SYSTEM REMOVAL/INSTALLATION [LF].)
(3) Exhaust manifold insulator
(4) Wheels, tires and splash shields
(5) Under cover
(6) Starter
(See STARTER REMOVAL/INSTALLATION [LF].)

2. Drain the transaxle oil into a suitable container.

3. Remove in the order indicated in the table.

4. Install in the reverse order of removal.

5. Add the specified amount of specified transaxle oil.

Note
• If the transaxle is overhauled and installed to the vehicle, perform the 'INSPECTION AFTER TRANSAXLE OVERHAUL' and verify that there is no abnormality.
(See INSPECTION AFTER TRANSAXLE OVERHAUL [G35M-R].)

.

1
Back-up light switch connector
2
Neutral switch connector
3
Select cable
4
Shift cable
5
Harness bracket
6
Clutch release cylinder
7
Transaxle mounting bolt (upper side)
8
Tie-rod end ball joint
9
Stabilizer control link
10
Lower arm ball joint
11
Drive shaft
12
Joint shaft
13
No.1 engine mount rubber
14
Battery tray bracket
15
No.4 engine mount rubber
16
No.4 engine mount bracket
17
Transaxle mounting bolt (lower side)
18
Manual transaxle
(See Manual Transaxle Removal Note.)
(See Manual Transaxle Installation Note.)

Shift Cable And Select Cable Removal Note

1. Remove the both shift cable end and select cable end using a fastener remover.

No.4 Engine Mount Removal Note

1. Insert a wood slab of appropriate size between the front fender panel and upper apron reinforcement.

Note
• Wood slab height
4SD : approx. 35 mm
5HB : approx. 60 mm
• Cut the wood slab into two pieces and insert.

2. Support the engine using the SST.

Note
• A hoist or small crane can be used in place of the SST (49E 017 5A0).

3. Remove the battery tray bracket, No.4 engine mount rubber and bracket.

Manual Transaxle Removal Note

1. Loosen the part marked A and lean the engine toward the transaxle.

2. Support the transaxle on a jack.

3. Remove the transaxle mounting bolts.

4. Remove the transaxle.

Manual Transaxle Installation Note

1. Set the transaxle on a jack and lift into place.

2. Install the transaxle mounting bolts.

3. Tighten the SST (49 E017 5A0) so that the engine is located at the specified position.

No.1 Engine Mount and No.4 Engine Mount Installation Note

1. Install the No.4 engine mount bracket on the transaxle case and tighten bolt and nuts.

2. Install the No.1 engine mount rubber to the cross member and temporarily tighten bolts.

3. Place the No.4 engine mount rubber with the body stud bolts passing through the holes and tighten the bolt in the figure.

4. Place the battery tray bracket on the No.4 Engine mount rubber with the body stud bolts passing through the holes and tighten nuts in the figure.

5. Fully tighten the bolts.

6. Remove the SST (49 E017 5A0).