THEFT-DETERRENT SIREN REMOVAL/INSTALLATION [4SD]

1. Disconnect the negative battery cable.

2. Remove the following parts:

(1) Rear seat (See REAR SEAT REMOVAL/INSTALLATION.)

(2) Rear scuff plate (See REAR SCUFF PLATE REMOVAL/INSTALLATION.)

(3) Tire house trim (See TIRE HOUSE TRIM REMOVAL/INSTALLATION.)

(4) Trunk end trim (See TRUNK END TRIM REMOVAL/INSTALLATION.)

(5) Service hole cover (LH)

3. Remove in the order indicated in the table.

4. Install in the reverse order of removal.