ADJUSTMENT

1. Remove the floor console, release the lever and back off the cable adjuster locknut at the base of the lever.
2. Raise the vehicle, support safely and remove the wheel.
3. Remove the hole plug in the brake rotor.
4. Remove the brake caliper and hang out of the way with wire. Do not disconnect the fluid line.
5. Use a suitable prybar to pry up on the self-adjuster wheel until the rotor will not turn.
6. Return the adjuster 5 notches in the opposite direction. Make sure the rotor turns freely with a slight drag.
7. Install the caliper and check operation.