CAUTION
The fuel system is under constant pressure, even with the engine off. This pressure
must be relieved before disconnecting any fuel system component, fitting or
fuel line connection. Failure to do so may result in personal injury.
- Disconnect the fuel pump electrical connector, located at the rear side
of the fuel tank.
- Start the engine.
- After the engine stalls, turn the ignition switch OFF and
reconnect the fuel pump connector.
- Disconnect the negative battery cable, then continue with the service procedure.
- Turn the ignition switch to LOCK.
- Fold down the second seat.
- Remove the upper and lower service hole cover.
- Disconnect the fuel pump module connector.
- Start the engine and let it run out of fuel.
