Torsion Bars

REMOVAL & INSTALLATION

1. Before servicing the vehicle, refer to the precautions in the beginning of this section.
2. Support the lower arm with a jack.
3. Remove or disconnect the following:
   • Heat protector, right side only
   • Bump stopper
   • Anchor adjustment nut and arm assembly
   • Anchor collar
   • Torsion bar
   • Dust covers
   • Heat covers, right side only

   To install:

4. Install or connect the following:
   • Heat covers, right side only
   • Dust covers
   • Torsion bar
   • Anchor collar
   • Anchor adjustment nut and arm assembly. Torque the nut to 32 ft. lbs. (44 Nm).
   • Heat protector, right side only