Upper Control Arm

REMOVAL & INSTALLATION

1. Before servicing the vehicle, refer to the precautions in the beginning of this section.
2. Remove or disconnect the following:
   • Wheel assembly
   • Bumper stop
   • Anchor arm assembly adjustment nut
   • Brake hose clip and connection
   • Upper ball joint from knuckle
   • Brake hose clip
   • Rebound stopper(s)
   • Speed sensor bracket
   • Shim
   • Upper control arm

   To install:

3. Install or connect the following:
   • Upper control arm and shim. Torque the nuts to 80 ft. lbs. (108 Nm).
   • Speed sensor bracket
   • Rebound stopper(s)
   • Brake hose clip
   • Upper ball joint from knuckle. Torque the nut to 54 ft. lbs. (74 Nm).
   • New cotter pin
   • Brake hose clip and connection
   • Anchor arm assembly adjustment nut. Torque the nuts to 33 ft. lbs. (44 Nm).
   • Bumper stop
   • Wheel assembly