- Raise and safely support the vehicle on jackstands.
- Remove the wheel(s).
- Remove the rear brake caliper and mount (brake assembly) following procedures
given previously in this section, but with out disconnecting the hydraulic
line. Suspend the assembly with wire; do not allow the unit to hang by the
brake line.
- Make mating marks to show the relationship between the brake disc and hub;
pull the disc off the hub.
- Slide the rear brake disc onto the rear axle lug studs so that the matchmarks
are aligned.
- Install the rear brake caliper to the disc and brake mount — refer
to the procedures found in this section.
