REMOVAL & INSTALLATION

1. Disconnect the negative battery cable from the battery.
2. Remove the front center console from the Pick-up truck to gain access to the G-sensor and the System Control Unit (SCU).
3. Disconnect the electrical wiring to the G-sensor, then loosen and remove any retaining screws from the G-sensor. Remove the G-sensor from the vehicle.
4. The SCU is located behind the G-sensor. Disconnect the electrical wiring to the SCU, then remove the mounting screws. Extract the SCU from the vehicle.
5. To install, connect the wiring to the SCU and mount in place with the retaining screws.
6. Install the G-sensor with the mounting screws and connect the wiring.
7. Install the front center console to the vehicle, then connect the negative cable to the battery.