[ Model - ECLIPSE CROSS / Year - 2018 ]
DIAGNOSIS FUNCTION
2018 / ECLIPSE CROSS / EC - Workshop Manual
00 -GENERAL > 00 -GENERAL > HOW TO USE TROUBLESHOOTING/INSPECTION SERVICE POINTS > DIAGNOSIS FUNCTION
The diagnosis function retrieves diagnosis code and data list by M.U.T.-IIISE and enables the performance of the actuator test.
  • DIAGNOSIS CODE
  • Data list output
  • Actuator test
  • Diagnosis deletion using M.U.T.-IIISE
  • Freeze frame data
  • Status indication by diagnosis code
  • ECU information display
noteIf a diagnosis code is set, the "status indication by diagnosis code" informs users whether a mechanical problem currently exists (current trouble) or whether it existed before but normal operation has been restored (past trouble).
 
 
HOW TO READ DIAGNOSIS CODE
cautionBefore connecting or disconnecting the M.U.T.-IIISE, turn the ignition switch to the "LOCK" (OFF) position <except vehicles with Keyless Operation System (KOS)> or put the power supply mode is OFF <vehicles with Keyless Operation System (KOS)>.
 
 
 
Connect the M.U.T.-IIISE to the 16-pin diagnosis connector, and read the diagnosis code.
noteFor details on how to use the M.U.T.-IIISE, refer to the "M.U.T.-IIISE User’s Manual."
1. Ensure that the ignition switch is at the "LOCK" (OFF) position <except vehicles with KOS> or put the power supply mode is OFF <vehicles with KOS>.
2. Start up the personal computer.
3. Connect special tool V.C.I.-Lite USB cable (MB992747/MB992748) to V.C.I.-Lite (MB992744) and the personal computer.
4. Connect V.C.I.-Lite main harness A (MB992745) to the V.C.I.-Lite.
5. Connect the V.C.I.-Lite main harness A to the diagnosis connector of the vehicle.
note
  • When the V.C.I.-Lite is connected to the diagnosis connector, the V.C.I.-Lite indicator lamp will be illuminated in a green colour.
  • If the V.C.I.-Lite indicator lamp does not light in green, check the power supply and earth line of the diagnosis connector.
6. Start the M.U.T.-IIISE system on the personal computer and turn the ignition switch to the "ON" position <except vehicles with KOS> or put the power supply mode is ON <vehicles with KOS>.
7. Read the diagnosis code.
8. Disconnecting the M.U.T.-IIISE is the reverse of the connecting sequence, making sure that the ignition switch is at the "LOCK" (OFF) position <except vehicles with KOS> or put the power supply mode is OFF <vehicles with KOS>.
 
 
 
ERASING DIAGNOSIS CODE
cautionBefore connecting or disconnecting the M.U.T.-IIISE, turn the ignition switch to the "LOCK" (OFF) position <except vehicles with KOS> or put the power supply mode is OFF <vehicles with KOS>.
Connect the M.U.T.-IIISE to the diagnosis connector, and erase the diagnosis code. The procedure is the same as "How to Read Diagnosis Code."