Mitsubishi Motors Service Manual

2018 / ECLIPSE CROSS / EC - Workshop Manual

00 -GENERAL > 00 -GENERAL > HOW TO USE TROUBLESHOOTING/INSPECTION SERVICE POINTS > RELAY INSPECTION

RELAY CHECK

Part	No.	Part name	Relay type
Relay box	1	Security alarm relay	B
	2	Headlamp washer relay <Vehicles with headlamp washer>	B
	3	Heated windshield relay 1	A
	4	Throttle valve control servo relay	B
	5	Heated seat relay	B
	6	Engine control relay	A
	7	Fuel pump relay	B
	8	Starter relay
	9	Steering heater relay
	10	Fan control relay	C
	11	Headlamp relay (HI)	B
	12	A/C compressor relay
	13	Horn relay
	14	Condenser fan relay
	15	Heated windshield relay 2	A
	16	Rear A/C relay	A
J/B	17	Dead lock relay <RHD>	B
J/B	18	Blower relay	B

RELAY CHECK

Type A

Battery voltage	Terminal number	Normal condition
At no energisation	3 - 4	No continuity
With current supply [terminal 1 (+), terminal 2 (-)]	3 - 4	Continuity exists (2 ohms or less)

Type B

Battery voltage	Terminal number	Normal condition
At no energisation	2- 4	No continuity
With current supply [terminal 3 (+), terminal 1 (-)]	2- 4	Continuity exists (2 ohms or less)

Type C

Battery voltage	Terminal number	Normal condition
At no energisation	1 - 3	Continuity exists (2 ohms or less)
With current supply [terminal 4 (+), terminal 2 (-)]	1 - 3	No continuity