[ Model - ECLIPSE CROSS / Year - 2018 ]
PRINT
PRINT (GROUP)
| Adjustment item (M.U.T.-IIISE display) | Adjustment item | Adjusting content (M.U.T.-IIISE display) | Adjusting content |
| Turn power source | Adjustment of turn-signal lamp operation condition | ACC or IG1 | Operable with ACC or ON position |
| IG1 | Operable with ON position (initial condition) | ||
| Comfort flasher | With/without comfort flasher function | Disable | No function |
| Enable | With function (initial condition) | ||
| Hazard answer back | Adjustment of the number of keyless hazard warning lamp answer back flashes | Lock: 1, Unlock: 2 | LOCK: Flashes once, UNLOCK: Flashes twice (initial condition) |
| Lock: 1, Unlock: 0 | LOCK: Flashes once, UNLOCK: No flash | ||
| Lock: 0, Unlock: 2 | LOCK: No flash, UNLOCK: Flash twice | ||
| Lock: 2, Unlock: 1 | LOCK: Flash twice, UNLOCK: Flash once | ||
| Lock: 2, Unlock: 0 | LOCK: Flash twice, UNLOCK: No flash | ||
| Lock: 0, Unlock: 1 | LOCK: No flash, UNLOCK: Flash once | ||
| Lock: 0, Unlock: 0 | No function | ||
| Front wiper operation | Adjustment of the intermittent windshield wiper operation | Normal INT | Intermittent wiper interval is fixed to 4 seconds. |
| Variable INT | Intermittent wiper interval is calculated only by the wiper volume control. | ||
| Speed Sensitive | Intermittent wiper interval is calculated according to the intermittent wiper volume control and vehicle speed. | ||
| Rain Sensitive | Intermittent wiper interval is calculated according to the intermittent wiper volume control and lighting control sensor (initial condition). | ||
| Front/rear wiper washer | Disabling or enabling washer-linked wiper function | Only Washer | No function |
| Washer & Wiper | With function: Without delayed finishing wipe function | ||
| Washer & Wiper with after wiper | With function: With delayed finishing wipe function <Initial condition> | ||
| Intermittent time of rear wiper | Adjustment of rear wiper interval | 0 sec. | No wiper interval |
| 4 sec. | 4 seconds | ||
| 8 sec. | 8 seconds (initial condition) | ||
| 16 sec. | 16 seconds | ||
| Rear wiper low speed mode | Disabling or enabling rear wiper continuous operation | Disable | No function |
| Enable | With function (initial condition) | ||
| Auto fold mirror | Electric folding door mirror automatic unfolding function <Vehicles with electric retractable remote controlled door mirrors> | Not Auto | No synchronised operation |
| Open by vehicle speed | Vehicle speed-dependent operation | ||
| Open/Close by IG | Ignition switch linked operation | ||
| Open/Close by Keyless | Keyless entry linked operation (initial condition) | ||
| Sensitivity for auto lamp | Lighting control sensor sensitivity (illumination intensity) | Level 1 bright | High-high ambient brightness |
| Level 2 bright | High ambient brightness | ||
| Level 3 | Standard ambient brightness (initial condition) | ||
| Level 4 dark | Low ambient brightness | ||
| Level 5 dark | Low-low ambient brightness | ||
| Room lamp delay timer with door | Adjustment of interior lamp delay shutdown time | 0 sec. | 0 second (no delay shutdown time) |
| 7.5 sec. | 7.5 seconds | ||
| 15 sec. | 15 seconds (initial condition) | ||
| 30 sec. | 30 seconds | ||
| 60 sec. | 60 seconds | ||
| 120 sec. | 120 seconds | ||
| 180 sec. | 180 seconds | ||
| Head lamp auto cut customize | Adjustment of headlamp automatic shutdown function | Disable | No function |
| Enable (B-spec.) | With function (initial condition) | ||
| Interior lamp auto cut timer | Adjustment of interior lamp automatic shutdown function operation time | Disable | No function |
| 3 min | 3 minutes | ||
| 30 min | 30 minutes (initial condition) | ||
| 60 min | 60 minutes | ||
| Auto door unlock | Adjustment of the auto door unlock function | Disable | Without function <M/T, CVT> (initial condition) |
| Always(Shift P position) | With function: Operates when the shift lever or the selector lever is moved to the P position. <CVT> | ||
| Always(IG lock position) | With function: Operates when the ignition switch is moved to the LOCK (OFF) position. <M/T, CVT> | ||
| Door unlock mode | Adjustment of power door locks with selective unlocking <Vehicles without dead lock system> | All Doors unlock | Without function: The first operation of keyless entry system or unlock operation by KOS unlocks all doors (initial condition). |
| Driver's door unlock | With function: The first operation of keyless entry system or unlock operation by KOS unlocks the driver's door only, and the second unlock operation within 2 seconds after that unlocks all doors. | ||
| Deadlock button operation | Adjustment of the dead lock system setting procedure <vehicles with dead lock system> | Twice | Operate the lock switch of the keyless entry system or KOS twice.(initial condition) |
| Once | Operate the lock switch of the keyless entry system or KOS once. | ||
| Timer lock timer | Timer lock period adjustment | 30 sec. | 30 seconds (initial condition) |
| 60 sec. | 60 seconds | ||
| 120 sec. | 120 seconds | ||
| 180 sec. | 180 seconds | ||
| Alarm | Enables/disables security alarm <Vehicles with security alarm> | Disable | Without function |
| Enable | With function (initial condition) | ||
| Duration of pre-alarm | Adjustment of pre-alarm (interior alarm) continue time <Vehicles with security alarm (Without security alarm sensor)> | 10 sec. | 10 seconds (initial condition) |
| 6 sec. | 6 seconds | ||
| Multi mode | Multi-mode keyless entry function customisation <Vehicles with electric retractable remote controlled door mirrors> | Disable | No function |
| D/M: Open & Close | Door mirror fold/unfold operation only (initial condition) | ||
| KOS key detect out from window | With/without KOS key exterior detection function <Vehicles with KOS> | Enable | No function |
| Disable | With function (initial condition) | ||
| KOS feature | KOS function adjustment <Vehicles with KOS> | Both enable | All KOS functions are enabled (initial condition). |
| Door entry enable | Only door entry function is enabled. | ||
| ENG start enable | Only engine starting function is enabled. | ||
| Both disable | All KOS functions are disabled. | ||
| KOS unlock disable time | Adjusts the door unlock inhibition period after door lock is activated. <Vehicles with KOS> | 0 sec. | 0 second |
| 3 sec. | 3 seconds (Initial condition) | ||
| 5 sec. | 5 seconds | ||
| ACC power auto cut time | Time to ACC power cut-off when the ignition switch is in the ACC position | Disable | No function |
| 30 min | 30 minutes (initial condition) | ||
| 60 min | 60 minutes | ||
| Comfort flasher switch time | Switch operation time to activate the comfort flasher function | Normal | 0.4 second (initial condition) |
| Long | 0.8 second | ||
| Intelligent/Comfort washer | With/without Comfort washer function | Disable | No function |
| Enable | With function | ||
| Coming home lamp | Disabling or enabling coming home light function | Disable | No function |
| 15 sec. | The headlamps illuminate for 15 seconds. | ||
| 30 sec. | The headlamps illuminate for 30 seconds. (initial condition) | ||
| 60 sec. | The headlamps illuminate for 60 seconds. | ||
| 180 sec. | The headlamps illuminate for 180 seconds. | ||
| Welcome lamp | Disabling or enabling welcome light function | Disable | No function |
| Small lamp | The tail lamps illuminate. <initial condition> | ||
| Headlamp | The headlamps illuminate. | ||
| Rear wiper (linked reverse gear) | Adjustment of automatic rear window wiper operation with reverse gear engaged | Enable(Rear wiper ON) | Operates only when the rear wiper switch is ON. |
| Enable(Rear/Front wiper ON) | Operates only when the front or rear wiper switch is ON (initial condition). | ||
| Sensitivity for security sensor | Sensitivity level setting of security alarm sensor <Vehicles with security alarm (With security alarm sensor)> | Level 1 | 100% sensitivity of security alarm sensor (initial condition) |
| Level 2 | 90% sensitivity of security alarm sensor | ||
| Level 3 | 80% sensitivity of security alarm sensor | ||
| Level 4 | 70% sensitivity of security alarm sensor | ||
| Outer buzzer volume | KOS outer buzzer volume adjustment <Vehicles with KOS> | Volume 1 | Quieter than the standard |
| Volume 2 | Standard volume (Initial condition) | ||
| Volume 3 | Louder than the standard | ||
| A/C recirculation control | With/without inside/outside air automatic control function | Disable | No function |
| Enable | With function (Initial condition) | ||
| A/C switch control | With/without A/C automatic control function | Disable | No function |
| Enable | With function (Initial condition) | ||
| A/C sensible temperature customize | Adjusting mean value for temperature setting | -2 | Decreases the control temperature two degrees than the temperature displayed on the LCD. |
| -1 | Decreases the control temperature one degree than the temperature displayed on the LCD. | ||
| 0 | No change (Initial condition) | ||
| 1 | Increases the control temperature one degree than the temperature displayed on the LCD. | ||
| 2 | Increases the control temperature two degrees than the temperature displayed on the LCD. | ||
| ECO mode | Function to activate ECO mode air-conditioner | ECO | Activates the ECO mode. |
| Comfort | Deactivates the ECO mode. | ||
| FOOT / DEF air outlet ratio | Changes air distribution rate for DEF/FOOT vents during manual operation. | Normal | D/F2 (Initial condition) |
| FOOT > DEF | D/F1(more to FOOT vent): More air flows through FOOT vents. | ||
| FOOT < DEF | D/F3(more to DEF vent): More air flows through DEF vents. | ||
| FACE / FOOT air outlet ratio | Changes air distribution rate for FACE/FOOT vents during manual operation. | Normal | B/L2 (Initial condition) |
| FACE > FOOT | B/L1(more to FACE vent): More air flows through FACE vents. | ||
| FACE < FOOT | B/L3(more to FOOT vent): More air flows through FOOT vents. | ||
| Auto rear defogger (Engine start) | Activates the rear window defogger when the ambient temperature is low. (The rear window defogger has never been activated since the ignition switch was turned on last time) | Disable | No function (Initial condition) |
| Enable | With function |
| Item No. | Item name (M.U.T.-IIISESE display) | Adjusting content (M.U.T.-IIISESE display) | Adjusting content |
| 1 | Signal sound setting | Type 1 | Customising turn-signal sound |
| Type 2 |