[ Model - ECLIPSE CROSS / Year - 2018 ]
INITIALISATION PROCEDURE FOR LEARNING VALUE IN DI AND MPI ENGINE
2018 / ECLIPSE CROSS / EC - Workshop Manual
00 -GENERAL > 00 -GENERAL > PRECAUTIONS BEFORE SERVICE > INITIALISATION PROCEDURE FOR LEARNING VALUE IN DI AND MPI ENGINE
 
 
Initialise learning values in the DI and MPI engine when one of the following service operations is performed.
  • At replacing engine assembly *
  • At replacing injector and at cleaning
  • At replacing injector (high pressure) and at cleaning
  • At replacing throttle body and at cleaning
  • At replacing detonation sensor
note*: Initialise CVT related learning value.
 
 
 
INITIALISATION PROCEDURE
 
 
 
cautionTo prevent damage to M.U.T.-IIISE, always turn the ignition switch to the "LOCK" (OFF) position before connecting or disconnecting M.U.T.-IIISE.
1. After the ignition switch is in "LOCK" (OFF) position, connect the M.U.T.-IIISE to the diagnosis connector.
2. Turn the ignition switch to the "ON" position.
3. Select "MPI/GDI/DIESEL" from System select Screen of the M.U.T.-IIISE.
4. Select "Special Function" from MPI/GDI/DIESEL Screen.
5. Select "Learned value reset" from Special Function Screen.
6. Select "All learned value" from Learned value reset Screen
7. Initialise the learning value by pressing the "OK" button.
8. After initialising the learning value, the learning value of DI and MPI engine idling is necessary. Learning procedure for idling in DI and MPI engine (Refer to ).