[ Model - ECLIPSE CROSS / Year - 2018 ]
FUEL PUMP (HIGH PRESSURE) CHECK
2018 / ECLIPSE CROSS / EC - Workshop Manual
13 -FUEL > 13A-DIRECT INJECTION AND MULTIPOINT FUEL INJECTION (DI AND MPI) > ON-VEHICLE SERVICE > FUEL PUMP (HIGH PRESSURE) CHECK
 
 
MEASUREMENT OF RESISTANCE
 
1. Disconnect the fuel pump (high pressure) connector.
2. Measure the resistance between terminals.
Standard value: 0.45 - 0.55 Ω (at 20°C)
3. Measure the resistance between fuel pump (high pressure) body and either terminal No. 1 or terminal No. 2 of the connector at the fuel pump (high pressure).
Standard value: No continuity
4. If the resistance is deviates from the standard value, replace the fuel pump (high pressure).