2018 / ECLIPSE CROSS / EC - Workshop Manual
13 -FUEL > 13A-DIRECT INJECTION AND MULTIPOINT FUEL INJECTION (DI AND MPI) > ON-VEHICLE SERVICE > LINEAR A/F SENSOR CHECK
1. Disconnect the linear A/F sensor connector.
2. Measure the resistance between terminal No. 4 and No. 5 of the linear A/F sensor connector.Standard value: 2.3 - 4.2 Ω (at 20°C)
3. If the resistance deviates from the standard value, replace the linear A/F sensor.| note | For removal and installation of the linear A/F sensor, refer to GROUP 15 - Exhaust Pipe, Main Muffler And Catalytic Converter - Removal and Installation  . |
