2018 / ECLIPSE CROSS / EC - Workshop Manual
13 -FUEL > 13A-DIRECT INJECTION AND MULTIPOINT FUEL INJECTION (DI AND MPI) > TROUBLESHOOTING > ACTUATOR TEST REFERENCE TABLE
ACTUATOR TEST REFERENCE TABLE
Item No.Inspection ItemDrive contentInspection conditionNormal condition
1Injector stopCut off No. 1 injectorEngine: After warm-up, idle operation (Cut off injectors sequentially to check for a cylinder that does not change engine in idle status)Engine is changed (becomes unstable or stalled)
Cut off No. 2 injector
Cut off No. 3 injector
Cut off No. 4 injector
2Fuel pump ONDrive fuel pump to circulate fuel
  • Ignition switch: ON
  • Check for pump operating noise near fuel tank
Operating noise audible
3Fuel pump OFFStop driving the fuel pump and stop fuel circulation
  • Ignition switch: ON
  • Check for pump operating noise near fuel tank
Operating sound cannot be heard.
4Purge control solenoid valve ONSwitch solenoid valve from OFF to ONIgnition switch: ONWhen the valve is actuated, operating noise is audible
5Purge control solenoid valve OFFSwitch solenoid valve from ON to OFFIgnition switch: ONWhen the valve is actuated, operating sound cannot be heard.
7Cooling fan ONActuate the fan motorIgnition switch: ONFan motor rotates at high speed
8Cooling fan OFFStop the rotation of the fan motorIgnition switch: ONFan motor with a high speed stops
11A/C compressor relay ONSwitch the A/C compressor relay from OFF to ONIgnition switch: ONThe operating sound of A/C compressor is audible
12A/C compressor relay OFFSwitch the A/C compressor relay from ON to OFFIgnition switch: ONOperating sound of the A/C compressor cannot be heard
13Oil feeder control valve ONSwitch the inlet oil feeder control valve and exhaust oil feeder control valve from OFF to ONIgnition switch: ONWhen the valve is actuated, operating noise is audible
14Oil feeder control valve OFFSwitch the inlet oil feeder control valve and exhaust oil feeder control valve from ON to OFFIgnition switch: ONOperating sound cannot be heard.