[ Model - ECLIPSE CROSS / Year - 2018 ]
2018 / ECLIPSE CROSS / EC - Workshop Manual
13 -FUEL > 13A-DIRECT INJECTION AND MULTIPOINT FUEL INJECTION (DI AND MPI) > TROUBLESHOOTING > SYMPTOM PROCEDURES > IN RUNNING, THE ECO MODE INDICATOR SHOWS NOTHING
Inspection Procedure 30: In Running, The ECO Mode Indicator Shows Nothing
 
 
 
 
COMMENTS ON TROUBLE SYMPTOM
  • Under a good driving conditions of fuel consumption, the engine-ECU shows ECO mode indicator through the CAN.
  • If the engine-ECU does not show ECO mode indicator no matter how the vehicle runs, the possible causes are a abnormal combination meter, also abnormal communication between the engine-ECU and the combination meter.
 
 
PROBABLE CAUSES
  • Failed ECO mode indicator
  • Open/short circuit in combination meter circuit
 
 
DIAGNOSIS PROCEDURE
STEP 1. M.U.T.-IIISE diagnosis code
Is the diagnosis code set?
Inspection chart for diagnosis code (Refer to ).
Go to Step 2.
 
STEP 2. Check the trouble symptom.
Does the trouble symptom persist?
Check combination meter system (Refer to GROUP 54A - Combination Meter - Trouble Symptom Chart ).
Intermittent malfunction (Refer to GROUP 00 - How to Use Troubleshooting/Inspection Service Points - How to Cope with Intermittent Malfunctions ).