2018 / ECLIPSE CROSS / EC - Workshop Manual
14 -ENGINE COOLING > ON-VEHICLE SERVICE > ENGINE COOLANT LEAK CHECK
1. | warning | When pressure testing the cooling system, slowly release cooling system pressure to avoid getting burned by hot coolant. |
| caution | - Be sure to completely clean away any moisture from the places checked.
- When the tester is taken out, be careful not to spill any coolant.
- Be careful when installing and removing the tester and when testing not to deform the filler neck of the radiator.
|
Check that the coolant level is up to the filler neck. Install a radiator tester and apply 160 kPa pressure, and then check for leakage from the radiator hose or connections.
2. If there is leakage, repair or replace the appropriate part.
