Mitsubishi Motors Service Manual

ADAPTIVE CRUISE CONTROL SYSTEM COMPONENT CHECK

2018 / ECLIPSE CROSS / EC - Workshop Manual

17 -ENGINE AND EMISSION CONTROL > ADAPTIVE CRUISE CONTROL SYSTEM (ACC) > ON-VEHICLE SERVICE > CRUISE CONTROL SYSTEM COMPONENT CHECK

CRUISE CONTROL SWITCH CHECK

1. Remove the cruise control switch (Refer to

2. Measure the resistance between terminal No.1 and terminal No.2 when each of the ACC distance switches is pressed. Measure the resistance between terminal No.3 and terminal No.4 when each of the speed limiter ON/OFF, ACC ON/OFF, CANCEL, SET - and RES + switches is pressed. If the values measured at the time each switch is pressed correspond to those in the table below, the resistance values are correct.

Terminal connector of tester	Switch position	Specified condition
1 - 2	ACC distance switch is pressed	Continuity (less than 2Ω)
3 - 4	All switches are released.	Open circuit
	Speed limiter ON/OFF switch is pressed	Continuity (less than 2Ω)
	ACC ON/OFF switch is pressed	176 - 180 Ω
	CANCEL switch is pressed	460 - 470 Ω
	SET - switch is pressed	1030 - 1051 Ω
	RES + switch is pressed	2725 - 2837 Ω

3. Check that illumination of the cruise control switch turns on when the battery positive terminal is connected to cruise control switch connector terminal No.5, and the battery negative terminal is connected to cruise control switch connector terminal No.6.