[ Model - ECLIPSE CROSS / Year - 2018 ]
2018 / ECLIPSE CROSS / EC - Workshop Manual
17 -ENGINE AND EMISSION CONTROL > CRUISE CONTROL > DATA LIST REFERENCE TABLE
DATA LIST REFERENCE TABLE
caution
  • Road test always needs two people: one driver and one observer.
  • When shifting the selector lever to "D" position the brakes should be applied so that the vehicle does not move forward. <CVT>
Item No.Check itemCheck conditionNormal condition
4Vehicle speedRoad test the vehicle.The speedometer and M.U.T.-IIISE display the same value.
57Cancel codeIgnition switch: "ON"The cancel code, which set when the cruise control system was cancelled at the last time, is set again.
74Stop lamp switch (for stop lamp circuit)Ignition switch: "ON"Brake pedal: DepressedON
Brake pedal: ReleasedOFF
75Cruise control switches (CANCEL switch)Ignition switch: "ON"CANCEL switch: PressedON
CANCEL switch: ReleasedOFF
78Clutch switch <M/T>Ignition switch: "ON"Clutch pedal: DepressedON
Clutch pedal: ReleasedOFF
81Cruise control operationCruise control: activeON
Cruise control: InactiveOFF
82Cruise control switches (speed limiter main switch)Ignition switch: "ON"Speed limiter ON/OFF switch: PressedON
Speed limiter ON/OFF switch: ReleasedOFF
86Cruise control switches (Cruise control ON/OFF switch)Ignition switch: "ON"Cruise control ON/OFF switch: PressedON
Cruise control ON/OFF switch: Pressed againOFF
88Inhibitor switch <CVT>Ignition switch: "ON"Selector lever: "N" or "P" positionON
Selector lever: Other than "N" or "P" positionOFF
89Brake switch (for cruise control circuit)Ignition switch: "ON"Brake pedal: DepressedON
Brake pedal: ReleasedOFF
91Cruise control switches (RES + switch)Ignition switch: "ON"RES + switch: PressedON
RES + switch: ReleasedOFF
92Cruise control switches (SET - switch)Ignition switch: "ON"SET - switch: PressedON
SET - switch: ReleasedOFF