2018 / ECLIPSE CROSS / EC - Workshop Manual
17 -ENGINE AND EMISSION CONTROL > ADAPTIVE CRUISE CONTROL SYSTEM (ACC) > DIAGNOSIS CODE PROCEDURES > CODE NO. C1754: ACC/FCM RADAR CALIBRATION NOT COMPLETED
Code No. C1754: Radar Calibration not Completed
OPERATION
The ACC/FCM-ECU memorises the neutral position of its radar.
DIAGNOSIS CODE SET CONDITION
Check Condition
- Ignition switch is "ON" position.
Judgement Criterion
- The ACC/FCM-ECU detects that the neutral position of its radar is not learned yet.
| note | A diagnosis code is not set as a historic fault. |
PROBABLE CAUSES
- Neutral position of ACC/FCM-ECU radar not learned
DIAGNOSIS PROCEDURE
STEP 1. ACC/FCM-ECU radar calibration
).
This diagnosis is complete.
Check the conditions and carry out calibration again.