[ Model - ECLIPSE CROSS / Year - 2018 ]
PURGE CONTROL SOLENOID VALVE CHECK
2018 / ECLIPSE CROSS / EC - Workshop Manual
17 -ENGINE AND EMISSION CONTROL > EMISSION CONTROL > EVAPORATIVE EMISSION CONTROL SYSTEM > PURGE CONTROL SOLENOID VALVE CHECK
 
 
noteWhen removing the vacuum hose, always make a mark so that it can be reconnected at original position.
1. Remove the vacuum hoses from the purge control solenoid valve.
2. Disconnect the purge control solenoid valve connector.
 
3. Connect a hand vacuum pump to nipple (A) of the solenoid valve (refer to the illustration at left).
4. Check airtightness by applying vacuum with voltage applied directly from the battery to the solenoid valve and without applying voltage.
 
Battery voltageState of nipple BNormal condition
AppliedOpenedVacuum leaks
pluggedVacuum maintained
Not appliedOpenedVacuum maintained
 
5. Measure the resistance between the terminals of the solenoid valve.
Standard value: 21 - 27 Ω (at 20°C)