[ Model - ECLIPSE CROSS / Year - 2018 ]
SELECTOR LEVER ASSEMBLY CONTINUITY CHECK
2018 / ECLIPSE CROSS / EC - Workshop Manual
23 -AUTOMATIC TRANSMISSION > 23A-CVT > TRANSMISSION CONTROL > SELECTOR LEVER ASSEMBLY CONTINUITY CHECK
 
 
SWITCH CHECK
 
 
ItemSelector lever positionTerminal numberContinuity
P position detect switch <Vehicles with KOS>P3 - 6No continuity
Other than above3 - 6Continuity
P position detect switch <Vehicles without KOS>P6 - 12No continuity
Other than above6 - 12Continuity
Select switchSport mode6 - 11Continuity
Other than aboveNo continuity
Shift switch (UP)Upshift and hold6 - 13Continuity
Other than aboveNo continuity
Shift switch (DOWN)Downshift and hold6 - 14Continuity
Other than aboveNo continuity
 
 
 
KEY LOCK RELAY CHECK <VEHICLES WITHOUT KOS>
1. Shift the selector lever to P position.
2. Use a jumper wire to connect terminal No. 12 of the selector lever assembly connector to the battery (+) terminal, terminal No. 6 to the battery (-) terminal. Then apply battery voltage.
3. Check for continuity between the selector lever assembly connector terminals No. 3 and No. 12.
 
Jumper wireContinuity between terminals No. 3 and No. 12
ConnectYes (2 Ω or less)
DisconnectNo