[ Model - ECLIPSE CROSS / Year - 2018 ]
2018 / ECLIPSE CROSS / EC - Workshop Manual
23 -AUTOMATIC TRANSMISSION > 23A-CVT > TROUBLESHOOTING<S-AWC><S-AWC> > SPECIAL FUNCTION
SPECIAL FUNCTION
RESET
Item No.Display on M.U.T.-IIISEInitialisation contents
1Steering angle adjusted valueResets the steering wheel sensor neutral position learned value.
3Center coupling estimated temperatureReset the estimated temperature of coupling.
TEST
Item No.Display on M.U.T.-IIISETest contentNormal conditions
1Control OFFThe electronic control coupling operation stopsRefer to the electronic control coupling operation check .
3Center coupling operation checkDrive the electronic control coupling with control current of 3 A.Maximum 60 seconds
1. The test can be performed only when all the following conditions are satisfied.
  • Every wheel speed sensor input is 20 km/h or less.
  • No system malfunction is detected.
  • The steering angle of steering wheel is within ±30° from the neutral position.
2. With the test, when any of the conditions below is met, the forced activation will be cancelled.
  • Any of the wheel speed sensors detects an input of 20 km/h or more (excluding item No. 1 "Control OFF").
  • A system malfunction is detected.
  • The forced activation time has elapsed.
  • M.U.T.-IIISE is removed.
  • M.U.T.-IIISE clear key is operated.
The sensor neutral position learned value initialisation can be performed only when the vehicle is stopped.