2018 / ECLIPSE CROSS / EC - Workshop Manual
27 -REAR AXLE > 27B-REAR AXLE<4WD> > ON-VEHICLE SERVICE > GEAR OIL CHANGE
1. Remove the filler plug.
2. Remove the drain plug and drain oil.
3. Tighten the drain plug to the specified torque.Tightening torque: 32 ± 2 N·m
4. Fill the oil until the level comes to the lower portion of the filler plug hole.Specified gear oil: MITSUBISHI MOTORS GENUINE super hypoid gear oil API classification GL-5, SAE 80Amount to use: approx. 0.4 L
5. Tighten the filler plug to the specified torque.Tightening torque: 32 ± 2 N·m
