[ Model - ECLIPSE CROSS / Year - 2018 ]
2018 / ECLIPSE CROSS / EC - Workshop Manual
32 -POWER PLANT MOUNT > ENGINE MOUNTING > ENGINE MOUNTING REMOVAL AND INSTALLATION
REMOVAL AND INSTALLATION
 
 
Pre-removal and post-installation operation
Engine Room Under Cover Front A, B Removal and Installation (Refer to GROUP 51 - Under Cover ).
 
Removal
<<A>>>>A<<1.Engine mounting bracket
 
 
REMOVAL SERVICE POINT
 
 
<<A>> ENGINE MOUNTING BRACKET REMOVAL
1. Place a garage jack against the engine oil pan with a piece of wood in between to support the engine and transmission assembly.
cautionWhen supporting the engine and transmission assembly with a garage jack, be careful not to deform the engine oil pan.
2. Operate a garage jack so that the engine weight is not applied to the engine mounting bracket, and remove the engine mounting bracket.
 
 
 
 
INSTALLATION SERVICE POINT
 
 
>>A<< ENGINE MOUNTING BRACKET INSTALLATION
cautionDo not remove small tapping screw on the back side.
 
Tighten the engine mounting bracket mounting bolts by the following procedure.
 
OrderBoltTightening torque
1stAApproximately 0 - 5.0 N·m
2ndB50 ± 5 N·m
3rdA50 ± 5 N·m