[ Model - ECLIPSE CROSS / Year - 2018 ]
REAR WHEEL ALIGNMENT CHECK AND ADJUSTMENT
2018 / ECLIPSE CROSS / EC - Workshop Manual
34 -REAR SUSPENSION > ON-VEHICLE SERVICE > REAR WHEEL ALIGNMENT CHECK AND ADJUSTMENT
1. Before the wheel alignment measurement, adjust the rear suspension, wheel, and tyres in good condition.
2. Park the vehicle on a level surface to measure the wheel alignment.
 
 
 
 
TOE-IN
Standard value:
  • At the centre of tyre tread: 3 ± 2 mm
  • Toe-angle (per wheel): 0°08’ ± 0°05’
If it is out of the standard range, adjust as follows:
 
Turn the toe adjusting bolt (the mounting bolt inside the body on the control link) to adjust.
Left wheel: Clockwise (+) Toe in
Right wheel: Clockwise (-) Toe in
Toe-in varies approximately 3.2 mm (equivalent to 0°16' of the toe angle for one side) for each scale mark.
 
 
 
 
CAMBER
Standard value: -0°40' ± 0°45'
 
note
  • Difference between right and left wheels must be 0°30' or less.
  • The camber is pre-adjusted at factory and is not adjustable.
  • As for vehicles with aluminium wheel, use a compensator to measure the camber and caster.