[ Model - ECLIPSE CROSS / Year - 2018 ]
STOP LAMP SWITCH CHECK
2018 / ECLIPSE CROSS / EC - Workshop Manual
35 -SERVICE BRAKES > 35A-BASIC BRAKE > BRAKE PEDAL > INSPECTION > STOP LAMP SWITCH CHECK
 
 
cautionDo not apply lubricant (grease or silicon system sprayer etc.) to the switch and the switch installation section to avoid malfunction of the switch. In addition, do not use gloves which have lubricant (grease or silicon system sprayer etc.) on them.
 
Check for continuity between the terminals of the switch.
 
Check conditionTerminal connector of testerNormal condition
At free position1 - 2 (for stop lamp switch)Continuity exists
(2 Ω or less)
3 - 4 (for cruise control)No continuity
Press the plunger from the edge of the outer case by the dimension shown in the figure.1 - 2 (for stop lamp switch)No continuity
3 - 4 (for cruise control)Continuity exists
(2 Ω or less)