2018 / ECLIPSE CROSS / EC - Workshop Manual
35 -SERVICE BRAKES > 35A-BASIC BRAKE > BRAKE PEDAL > INSPECTION > BRAKE PEDAL DISTORTION CHECK
1. Place the brake pedal assembly on a level surface as shown in the figure, and set the distance from the centre of the pin assembly mounting hole to the level surface to 97 mm. Make sure that the dimension A in the figure (distance from the pedal pad surface to the level surface) is within the standard value.Standard value (A):241 - 247 mm <LHD (M/T)>
243 - 249 mm <LHD (A/T)>
247 - 253 mm <RHD (M/T)>
249 - 255 mm <RHD (A/T)>
2. When dimension A is not within the standard value, replace the brake pedal assembly.
