[ Model - ECLIPSE CROSS / Year - 2018 ]
2018 / ECLIPSE CROSS / EC - Workshop Manual
35 -SERVICE BRAKES > 35C-ACTIVE STABILITY CONTROL SYSTEM (ASC) > TROUBLESHOOTING<ASC-ECU><ASC-ECU> > DIAGNOSIS CODE PROCEDURES > CODE NO. C1801 ACC/FCM Auto Stop lamp monitor
Code No.C1801 Auto Stop Lamp Monitor
 
 
cautionBefore replacing the ECU, ensure that the communication circuit is normal.
 
 
OPERATION
The ASC-ECU illuminates the stop lamp while the ACC or the FCM is braking the vehicle automatically. The ASC-ECU monitors whether the stop lamps illuminate or go out.
 
 
 
DIAGNOSIS CODE SET CONDITIONS
The ASC-ECU sets the diagnosis code when it detects a malfunction during monitoring.
 
 
 
PROBABLE CAUSES
  • Damaged wiring harness and connectors
  • Malfunction of ETACS-ECU
  • Malfunction of ASC-ECU
 
 
 
 
DIAGNOSIS PROCEDURE
STEP 1. Check the stop lamp switch.
The stop lamps should illuminate when the brake pedal is depressed.
Is the check result normal?
Go to Step 2.
Carry out troubleshooting for the stop lamps. Refer to GROUP 54A - Rear Combination Lamp .
 
STEP 2. M.U.T.-IIISE actuator test
When the actuator test is performed, the stop lamps should illuminate.
  • Item 11: Stop lamp: ON (Refer to ).
Is the check result normal?
Go to Step 4.
Go to Step 3.
 
STEP 3. Check of short to power supply, short to earth, and open circuit in STLD line between ASC-ECU connector and ETACS-ECU connector
Is the check result normal?
Go to Step 4.
Repair the connector(s) or wiring harness.
 
STEP 4. Check of short to power supply, short to earth, and open circuit in STP line between ASC-ECU connector and stop lamp connector
Is the check result normal?
Go to Step 5.
Repair the connector(s) or wiring harness.
 
STEP 5. Check whether the diagnosis code is set again.
(1) Erase the diagnosis code.
(2) Ignition switch "LOCK" (OFF)
(3) Ignition switch "ON"
Is diagnosis code No.C1801 set?
Replace the hydraulic unit (integrated with ASC-ECU) (Refer to ).
Intermittent malfunction (Refer to GROUP 00 - How to Use Troubleshooting/How to Cope with Intermittent Malfunctions ).