[ Model - ECLIPSE CROSS / Year - 2018 ]
2018 / ECLIPSE CROSS / EC - Workshop Manual
36 -PARKING BRAKE > PARKING BRAKE LEVER<LEVER TYPE PARKING BRAKE><LEVER TYPE PARKING BRAKE> > PARKING BRAKE LEVER REMOVAL AND INSTALLATION
REMOVAL AND INSTALLATION
 
 
cautionDo not apply grease or lubricant to the switch and the switch installation section to avoid malfunction of the switch. In addition, do not use gloves which have grease on them.
Pre-removal operation
Floor Console Centre Assembly Removal (Refer to GROUP 52A - Front Floor Console Assembly ).
Post-installation operation
  • Parking Brake Lever Stroke Check (Refer to ).
  • Floor Console Centre Assembly Installation (Refer to GROUP 52A - Front Floor Console Assembly ).
 
Removal steps
•Release the parking brake lever.
•Loosen the adjusting nut.
1.Parking brake switch connector connection
>>A<<2.Parking brake rear cable assembly connection
3.Parking brake lever assembly
4.Parking brake switch
5.Adjusting nut
 
 
INSTALLATION SERVICE POINT
 
 
>>A<< PARKING BRAKE REAR CABLE INSTALLATION
cautionCheck that the equaliser and the parking brake rear cable are connected correctly. If the parking brake is applied with the equaliser and the parking brake rear cable connected improperly, the equaliser may be damaged.
 
Connect the parking brake rear cable to the equaliser as shown in the figure.