[ Model - ECLIPSE CROSS / Year - 2018 ]
2018 / ECLIPSE CROSS / EC - Workshop Manual
36 -PARKING BRAKE > TROUBLESHOOTING<ELECTRIC PARKING BRAKE><ELECTRIC PARKING BRAKE> > SYMPTOM PROCEDURES > The accelerator pedal-interlinked release function does not work.
Inspection Procedure 6: The accelerator pedal-interlinked release function does not work.
 
 
 
 
OPERATION
The system will release the electric parking brake without operating the electric parking brake switch when you start the vehicle by depressing the accelerator pedal.
 
 
COMMENTS ON TROUBLE SYMPTOM
This trouble symptom assumes that M.U.T.-IIISE CAN bus diagnosis result is OK and no diagnosis code is et.
 
 
PROBABLE CAUSES
  • Malfunction of the seat belt switch (driver's side)
  • Malfunction of the combination meter
  • Malfunction of the electric parking brake ECU
 
 
DIAGNOSIS PROCEDURE
STEP 1. Check the seat belt switch (driver's side).
Check the seat belt switch by observing the seat belt reminder.
  • Turn the ignition switch to the ON position.
 
Seat belt (driver's side)Seat belt warning lamp
FastenedOFF
UnfastenedON
Is the check result normal?
Go to Step 2.
Troubleshoot the combination meter. (Refer to GROUP 54A - Combination Meter .).
 
STEP 2. Retest the system
Is the check result normal?
Intermittent malfunction (Refer to GROUP 00 - How to Cope with Intermittent Malfunction ).
Replace the electric parking brake ECU (Refer to ).