2018 / ECLIPSE CROSS / EC - Workshop Manual
42 -BODY > 42A-BODY > HOOD > ON-VEHICLE SERVICE > ADJUSTMENT OF ALIGNMENT OF HOOD STEPPED PORTION AND HOOD STRIKER
1. Remove the headlamp support upper panel cover (Refer to GROUP 51, Radiator Grille 
). 2. Loosen the hood latch mounting bolts but do not remove them. Move the hood latch up/down and left/right to align the hood level and adjust the hood striker engagement.
3. After the adjustment, tighten the hood latch mounting bolts to 9.0 ± 1.0 N·m.
4. Install the headlamp support upper panel cover (Refer to GROUP 51, Radiator Grille ). 